Description

Wood Spade Drill Bits – Power through wood with speed and precision using our Wood Spade Drill Bits. These bits are expertly designed with a sharp, paddle-style tip and wide flutes to ensure fast chip removal, delivering clean, flat-bottom holes in both soft and hardwoods. Perfect for framing, cabinetry, and general carpentry, these drill bits are an essential tool for any woodworking project, providing efficiency and accuracy every time.

Additional information

Diameter Size

Various (See Above)

For Use On

Drywall, Insulation, Plaster, Plastic Conduit, PVC, Wood

Overall Length

Various (See Above)

Size Type

Fractional

FAQ's: Wood Drill Bits

Yes—easily, and it’s designed to clear chips as it drills deep holes.

The bit may be too small for the screw, or you’re not using enough torque.

No pilot hole, dull bit, drilling too close to edges, or drilling too fast.

The bit may be dull, the drill in reverse, or the wood too hard for the bit type.

Brad point, spade, and auger bits are wood-specific.

Use the drill’s standard setting with moderate speed—no hammer function.

Ship auger bits or flex bits for drilling through studs and joists.

Ship auger bits can reach 18" or more.

Brad point bits for precision, spade bits for speed, and auger bits for depth.

A hole saw or large Forstner bit.

For general use, a brad point bit. For deep holes, an auger bit.

Drilling clean, accurate holes in wood and similar soft materials.

Common types include twist bits, spade bits, auger bits, and Forstner bits.

No. Wood drills best dry; lubrication is for metal or masonry.

Moderate speed—too fast can burn the wood, too slow can cause tearing.

Dry wood. Wet wood can gum up bits, swell, and split when it dries.

Flat (spade) bits are faster and cheaper; hole saws cut cleaner and handle larger diameters better.

Wood bits have a point and spurs; steel bits are blunter with a chisel edge for cutting metal.

It has a sharp center point and often spurs on the edges.

Use a sharp bit, pre-drill pilot holes, avoid drilling too close to edges, and reduce speed near the end.

Match the bit type to the job—twist bits for small holes, spade bits for quick larger holes, and Forstner bits for clean, flat-bottom holes.

Use a drill guide or drill press. Without one, keep the drill steady and check alignment from multiple angles.

Use painter’s tape over the spot, drill slowly, and back the bit out gently before it breaks through.

Mark your spot, use a sharp wood bit, set the drill to medium speed, and apply steady pressure.

You’ll feel less resistance than with metal, and the shavings will be light, curly, and sawdust-like.

Look for a sharp center point and spurs on the edges—these help guide and cut clean holes in wood.

Yes, for best results. Wood bits have sharp points and spurs to cut fibers cleanly.

Not ideal. While metal bits can drill wood, they’re slower and less clean. Wood bits are designed for faster, cleaner cuts.

Not ideal. While metal bits can drill wood, they’re slower and less clean. Wood bits are designed for faster, cleaner cuts.

Yes. Auger bits are designed specifically for wood, cutting clean, deep holes quickly and efficiently.

Related Products